2007 Mercedes-benz Vito

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Prop shaft flexible coupling excessively deteriorated (6.1.7 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Headlamp aim too high (1.8)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear coil spring broken (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear brake disc worn, pitted or scored, but not seriously weakened Both (3.5.1i)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Child seat fitted not allowing full inspection of adult belt

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Stop lamp not working (1.2.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Inner Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel (3.1.6b)