2010 Subaru Outback

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear axle dry.

Nearside Inner tie rod ball joint has very slight play

Offside Inner tie rod ball joint has very slight play

Rear wiper blade smearing

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement both (2.4.G.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s/f o/s/f n/s/r o/s/r tyres perished/cracking on outer side walls

n/s/f o/s/f wiper blades starting to split on ends

n/s/f tyre has damage to outer side wall (cut)

Nail in nearside rear tyre

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)