2010 Honda Cr-v

Brake pedal wearing smooth (1.1.2 (c))

Front Anti-roll bar linkage ball joint has slight play both sides front (5.3.4 (a) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened both sides front inner (1.1.14 (a) (ii))

Rear Direction indicator slightly discoloured both sides rear (4.4.3 (a))

Nearside Rear Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pedal wearing smooth (1.1.2 (c))

Front Anti-roll bar linkage ball joint has slight play both sides front (5.3.4 (a) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened both sides front inner (1.1.14 (a) (ii))

Rear Direction indicator slightly discoloured both sides rear (4.4.3 (a))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning one of the bulb not working (4.2.1 (a) (i))

Nearside Rear parking brake low

Offside Rear parking brake slightly low

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

long hand brake travel

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) wearing thin and discs are lipped (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge 3mm wearing smooth on inner edge (5.2.3 (e))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm smooth on inner edge (5.2.3 (e))

Rear Exhaust mounting defective flanged joint / mounting (6.1.2 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Exhaust centre pipe and back box join corroded. However, not blowing and secure.

Under-trays fitted obscuring some underside components

Nearside Front Headlamp aim too low (1.8)

Under-trays fitted obscuring some underside components