2008 Peugeot 107

Front Subframe mounting prescribed area is corroded but not considered excessive rear and chassis (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear panel damaged no sharp edges

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides (6.2.2 (d) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Seat belt anchorage prescribed area is corroded but not considered excessive both side inner sill (7.1.1 (a) (i))

front discs corroded

front tyres cracking

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear at flexi joint (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Brake pipe excessively corroded front to rear corroded at flexi joint (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear at flexi joint (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Engine oil on minimum

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside rear brake binding (3.7.B.1)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Park brake lever close to no reserve limit

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)