2008 Seat Ibiza

Both front brake discs corroding

Both front brake discs slightly warped

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Rear Reverse light not working

Offside Rear Lower Outer sill corroded

Emissions unable to be completed (8.2.1.2 (d))

Nearside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords Outer sidewall (5.2.3 (d) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Both front brake discs corroding

Both front brake discs slightly warped

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Rear Reverse light not working

Offside Rear Lower Outer sill corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Offside Windscreen wiper not working (3.4 (a))

Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Upper Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)