2004 Fiat Panda

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill corroded (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill backings (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill backing (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Anti-roll bar linkage likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage likely to fail (5.3.3 (b) (ii)) DANGEROUS

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

hand brake too high

Brake fluid warning lamp illuminated (3.6.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake lever has little reserve travel (3.1.6b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

o/s headlamp aim on top limit

unable to fully check front to rear brake and fuel pipes due to covers

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

o/s headlamp aim on top limit

unable to fully check front to rear brake and fuel pipes due to covers