2014 Honda Cr-v

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Position lamp not working dip beam bulb (4.2.1 (a) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords bald on inner & cracking (5.2.3 (d) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Outer Tyre has a bulge, caused by separation or partial failure of its structure cut to cords (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm bald on inner to cords (5.2.3 (e)) DANGEROUS

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Tyre worn close to legal limit/worn on edge BOTH SIDES (5.2.3 (e))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords AND LOW (5.2.3 (d) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Tyre pressure monitoring system malfunctioning or obviously inoperative (5.2.3 (h))

Offside Rear Nail in tyre

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Brake pad(s) incorrectly mounted (1.1.13 (c)) DANGEROUS

Coil spring mounting damaged but not seriously weakened both rear upper spring mounts (5.3.1 (b) (i))

Coolant leak thermostat housing

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

TPMS light on

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning lower sidelight (4.2.1 (a) (i))

Rear Direction indicator slightly discoloured (4.4.3 (a))

general corrosion to underside of vehicle

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Worn on both edges (5.2.3 (e))

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

engine noise when tested oil level just over min

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted obscuring some components in the engine bay

Rear brake pads appear to be wearing low

Sill covers fitted unable to check sills for corrosion

Under-trays fitted obscuring some underside components