2003 Hyundai Getz

Front Brake pipe excessively corroded to rear (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Hydraulic fluid leaking excessively caliper (8.4.1 (a) (i))

Offside Front Outer Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

All suspension items front and rear have heavy corrosion

Brake fluid contaminated (1.8 (a))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Brake pipe excessively corroded wheel arch (1.1.11 (c))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded wheel arch (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

All suspension items front and rear have heavy corrosion

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Front Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Brake pipe excessively corroded front to rear marked yellow (1.1.11 (c))

Nearside Front Seat belt buckle not functioning as intended (7.1.2 (d))

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Brake pipe corroded, covered in grease or other material Front to rear (yellow) (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Stop lamp not working center (1.2.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe excessively corroded part of front to rear (3.6.B.2c)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

m.i.l lamp on

Front Exhaust has a minor leak of exhaust gases flexy (7.1.2)

Nearside Front Tyre worn close to the legal limit 2.20 MM (4.1.E.1)

Offside Front Tyre worn close to the legal limit 2.25 MM (4.1.E.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

P/A FRONT CV BOOTS CRACKING

Brake pipe slightly corroded rear ridgid brake pipe across axle (3.6.B.2c)

Tyre worn close to the legal limit both front tyres getting low on tread (4.1.E.1)

both head light lense covers deteriated

front flexi exhaust pipe blowing ( just okay at time of test)

both rear tyres badly cracking, no cords exposed, just ok at time of test

slight blow from exhaust centre section

surface corrosion on rear ridgid brake pipes

n/s rear tyre cracking in tread slightly

exhaust mid section deteriorated

nearside rear and offside rear tyres cracking slightly

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Front Brake pad(s) wearing thin (3.5.1g)