2011 Honda Insight

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Inner Play in steering rack inner joint(s)

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Patchy heavy in areas surface corrosion to underside of vehicle to, floor, inner sills (covers fitted), chassis, subframe rear suspension components (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Under-trays fitted front-rear

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Inner Play in steering rack inner joint(s)

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Patchy heavy in areas surface corrosion to underside of vehicle to, floor, inner sills (covers fitted), chassis, subframe rear suspension components (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Under-trays fitted front-rear

Front Brake lever has little reserve travel on limit at time of test will require attention soon

Integral body structure is corroded but structural rigidity is not significantly reduced Patchy surface corrosion on underside of vehicle to, chassis, floor, sills, subframes & suspension components (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Under-trays fitted front-rear

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle N/S lagging (1.2.1 (b) (i))

Front Brake lever has little reserve travel on limit at time of test will require attention soon

Integral body structure is corroded but structural rigidity is not significantly reduced Patchy surface corrosion on underside of vehicle to, chassis, floor, sills, subframes & suspension components (6.1.1 (c) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Under-trays fitted front-rear

Front Brake disc worn, pitted or scored, but not seriously weakened both front brake discs lipped / worn, advise change on next pad replacement (1.1.14 (a) (ii))

Nearside Rear Nail in tyre nail in n/s/r tyre

Nearside Rear Tyre slightly damaged/cracking or perishing n/s/r tyre perished on tread / weathered (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing o/s/r tyre perished on tread / weathered (5.2.3 (d) (ii))

Rear Outer Brake pad(s) wearing thin rear brake pads wearing low on outer, unable to inner pad (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin Just legal at time of test will require attention soon (1.1.13 (a) (ii))

Under Trays fitted front-rear

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge INNER TREAD (5.2.3 (e))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm bald on inner treads (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to the legal limit wearing on both edges (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre worn close to the legal limit wearing on both edges (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Items removed from driver's view prior to test

Under-trays fitted obscuring some underside components

Items removed from driver's view prior to test

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Under-trays fitted obscuring some underside components

Items removed from driver's view prior to test