2006 Peugeot 107

corrosion to rear axle

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

corrosion to rear axle

Offside Rear brake back plate corroded

Rear Suspension component corroded but not seriously weakened axle beam (5.3.3 (b) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Windscreen washer not working (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage attachment bracket/mounting fractured link arm broken (5.3.3 (b) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened x2 (1.1.14 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear brake back plate corroded

Rear Suspension component corroded but not seriously weakened axle beam (5.3.3 (b) (i))

Offside Rear back plate corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Registration plate inscription illegible (0.1 (b))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mounting (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Offside Rear back plate corroded

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

centre exhaust brakcet broken

Front Exhaust mounting defective (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

ecu light on

underside of vehicle clean and wax oiled

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

rear axle and prescribe area corroded

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

handbrake lever little reserve travel

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Position lamp not working (4.2.1 (a))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

handbrake lever little reserve travel

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Registration plate lamp not working both (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

small coolant leak from water pump and radiator

Nearside Front Front suspension has excessive movement at a wishbone pin or bush lower rear (2.5.A.1c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Items removed from driver's view prior to test

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)