2008 Toyota Aygo

UNDER BODY COVERED IN UNDERSEAL

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Parking (secondary brake) on a single line braking system grabbing severely (1.3.1 (c))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

UNDER BODY COVERED IN UNDERSEAL

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Parking brake inoperative on one side cable broken (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexi' (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material to cylinder (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material to flexi' (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Engine mounting damaged but not to excess (6.1.8 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material to flexi' (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material to cylinder (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material to flexi' (1.1.11 (c))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brakes imbalanced across an axle (3.7.B.5b)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)