2012 Yamaha Yzf

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front advice slight travel on lever

Brake performance not tested (1.2.1 (g))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Brake excessively binding (1.2.1 (f))

Front Brake lever has insufficient reserve travel (1.1.2 (a))

Headlamp aim too high (4.1.2 (a))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Brake excessively binding (1.2.1 (f))

Rear Suspension component pin or bush excessively worn (5.3.4 (a) (i))

Throttle operating incorrectly (6.2.7 (a) (i))

Rear Brake caliper inadequately mounted and braking performance affected (1.1.16 (c) (ii)) DANGEROUS

Clutch lever shortened (6.2.7 (b))

Nearside chain adjuster broken

Steering headbearing has slight free play (2.2.2 (f) (i))

Central Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Drive chain sprocket carrier worn to excess Cushdrive (6.2.1e)

Front Brake fluid reservoir fluid level dangerously low (3.2.B1d)

Front Brake lever has inadequate reserve travel (3.1.3b)

Front Floor brake test indicates a binding brake (3.3.C2c)

Front shock absorber seal failed and leaking oil (2.3.3)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Nearside Front Direction indicator damaged and function impaired (1.5.3a)

Nearside Rear Footrest missing (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Rear Brake disc(s) excessively worn (3.2.A1l)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear suspension movement is excessively stiff (2.4.A.3b)

Front Front wheel bearings not tested due to binding brake

Oil leak ()

Front shock absorber has light misting of stanchion (2.3.3)

All position lamps do not illuminate immediately when switched on (1.1.3a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Nearside Indicator switch defective (1.5.4)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front shock absorber has light misting of stanchion (2.3.3)