2001 Toyota Yaris

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill holed. (6.2.2 (d) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Upper Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Suspension Turret (6.2.2 (d) (i))

Nearside Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill (6.2.2 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Axle mountings (6.2.2 (d) (i))

Registration plate deteriorated but not likely to be misread Front and rear (0.1 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced side chassi (6.1.1 (c) (i))

Nearside Body component likely to become detached under plastic panel (6.2.1 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar attachment bracket/mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Anti-roll bar attachment bracket/mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

rear axle corroded

Exhaust emissions likely to be affected by an induction leak (8.2.2.1 (b))

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Windscreen wiper not operating automatically when switched on (8.2.1b)

Offside Front Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Rear registration plate delaminated but not likely to be misread (6.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Horn not working (1.6.2a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)