2007 Mazda 6

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Outer Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Outer Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases rear section (6.1.2 (a))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

The rear section of exhaust has advanced corrosion

Exhaust has a minor leak of exhaust gases rear section (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake pipe excessively corroded to flexi (1.1.11 (c))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Anti-roll bar ball joint likely to become detached already detached (5.3.4 (a) (ii)) DANGEROUS

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Anti-roll bar ball joint likely to become detached detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Exhaust system not adequately supported rear silencer bracket broken offside (7.1.1)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part hose insecure (bolt snapped) and fouling the tyre (3.6.B.4a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords tyre perished on inside wall revealing cords (4.1.D.1a) DANGEROUS

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords tyre perished revealing cords (4.1.D.1a) DANGEROUS

Front Brakes imbalanced across an axle (3.7.B.5b)

Offside Front front brake excessively fluctuating (3.7.B.3)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring broken (2.4.C.1a)

Offside Front coil spring broken (2.4.C.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nearside rear inner tyre wall perished

Offside Front wheel bearing rough when rotated (2.5.A.2)

nearside rear inner tyre wall perished

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)