2002 Mercedes-benz Vito

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive o/s and n/s (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Position lamp showing white light to the rear (4.2.3 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive o/s and n/s (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake disc worn, pitted or scored, but not seriously weakened o/s and n/s (1.1.14 (a) (ii))

Brake pad(s) wearing thin (1.1.13 (a) (ii))

Brake pipe corroded, covered in grease or other material all brake pipes (1.1.11 (c))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced o/s and n/s (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pipe corroded, covered in grease or other material All brake pipes greased (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Position lamp has a product on the lens or light source which shows white light to the rear (4.2.3 (b) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

front brake discs pitted and corroded

rear brake discs are pitted and corroded

slight exhaust blowing