2004 Fiat Panda

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake lagging in operation Slow to Respond (1.2.1 (d))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength AXLE Spring Seat (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge ON LIMIT (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Outer sill (5.3.6 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front drivers door handle sticking

Oil leak ()

Offside Front drivers door handle sticking

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Oil leak ()

oil leak, due to oil leak unable to check components properly-exhaust slightly blowing-n/s/r brake slightly binding-x2 rear coil springs corroded

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Suspension arm synthetic bush deteriorated resulting in excessive movement rear wishbone bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

oil leak, due to oil leak unable to check components properly-exhaust slightly blowing-n/s/r brake slightly binding-x2 rear coil springs corroded

Battery insecure (1.9.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Exhaust system not adequately supported (7.1.1)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

rear silencer outer skin peeling

advise rear exhaust rusty condition

Nearside Outer Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

advise rear exhaust rusty condition

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)