2005 Nissan Navara

Exhaust noisy (8.1.1 (a))

Front Prop shaft joint worn, but not excessively prop shaft rear u/j joint (6.1.7 (c) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output tinted (4.1.4 (b))

Nearside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity light uint tinted (4.2.3 (b) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output tinted (4.1.4 (b))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity light unit tinted (4.2.3 (b) (ii))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

load body corroded

Brake pedal has insufficient reserve travel when testing rear brakes in brake roller (1.1.2 (a))

Nearside Rear Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i))

Nearside Rear Rear reflector defective or damaged by more than 50% of the reflecting surface excessively tinted (4.8.1 (a) (ii))

Offside Rear Rear reflector defective or damaged by more than 50% of the reflecting surface excessively tinted (4.8.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring anchor mounting chassis leg (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Trailer electrical socket wiring insulation damaged or deteriorated and likely to cause a short-circuit (4.10 (b) (ii))

Exhaust noisy (8.1.1 (a))

Front Prop shaft joint worn, but not excessively prop shaft rear u/j joint (6.1.7 (c) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output tinted (4.1.4 (b))

Nearside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity light uint tinted (4.2.3 (b) (ii))

Offside Front Headlamp has a product on the lens but not seriously reducing light output tinted (4.1.4 (b))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Position lamp has a product on the lens or light source but not adversely affecting light intensity light unit tinted (4.2.3 (b) (ii))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

battery terminals loose

load body corroded

Exhaust noisy (8.1.1 (a))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Leaf spring has slight wear in an anchor pin and/or bush (5.3.4 (a) (i))

Nearside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity lamp unit tinted (4.2.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive spring anchor mounting(outer chassis leg) (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity lamp unit tinted (4.2.3 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

exhaust centre silencer and rear section missing

rear diff pinion flange slight play

service brake pedal spongy but still has reverse travel

trailer socket damaged but still secure

wing around fuel filler neck corroded

Front Exhaust has a major leak of exhaust gases flexi broken/blowing (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp light source and lamp not compatible (4.1.4 (c))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength spring anchor mounting x2 (5.3.6 (a) (i))

Nearside Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp light source and lamp not compatible (4.1.4 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Exhaust noisy (8.1.1 (a))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Leaf spring has slight wear in an anchor pin and/or bush (5.3.4 (a) (i))

Nearside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity lamp unit tinted (4.2.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive spring anchor mounting(outer chassis leg) (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Position lamp has a product on the lens or light source which obviously reduces light intensity lamp unit tinted (4.2.3 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

exhaust centre silencer and rear section missing

rear diff pinion flange slight play

service brake pedal spongy but still has reverse travel

trailer socket damaged but still secure

wing around fuel filler neck corroded

Nearside Rear Outer Vehicle structure is corroded but structural rigidity is not significantly reduced in front of rear wheel (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Fuel tank insecure securing band is corroded and has snapped off (6.1.3 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer chassis rail as marked rear leaf spring mounting area (5.3.6 (a) (i))

Nearside Rear Towbar excessively corroded within 30cm of towbar mounting Inner chassis rail (6.1.6 (i) (i))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Front Service brake lagging in operation When conducting brake imbalance test (1.2.1 (d))

Offside Rear Service brake lagging in operation When conducting brake imbalance test (1.2.1 (d))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Front leaf spring mount at outer chassis rail area (5.3.6 (a) (i))

Offside Rear Towbar excessively corroded within 30cm of towbar mounting Inner chassis rail as marked (6.1.6 (i) (i))

Service brake excessively fluctuating Both rear (1.2.1 (e))

Spare wheel carrier fractured Rear crossmember rotted out at both sides where joint to cahssis rails (6.1.5 (a))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Rear cross member for fuel tank/exhaust mounting within 30cms of a suspension mounting (5.3.6 (a) (i))

Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Spare wheel cross member (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner Chassis rail, leaf spring mounting and shock mounting area (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Outer chassis rail as marked (5.3.6 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Inner Chassis rail, leaf spring mounting and shock mounting area (5.3.6 (a) (ii)) DANGEROUS

Both front chassis rails have heavy surface corrosion

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened On inside (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Outer Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)