2008 Ford Ka

Front Position lamp not working Both (4.2.1 (a) (ii))

Nearside Front Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Sill to floor pan (6.2.2 (d) (i))

Nearside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Arch (6.2.2 (d) (i))

Nearside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Chassis leg bumper support (6.2.2 (d) (i))

Nearside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Sill / back axle (6.2.2 (d) (i))

Offside Front Outer Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Middle of sill (6.2.2 (d) (i))

Offside Rear Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Chassis leg (6.2.2 (d) (i))

Offside Rear Inner Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Arch (6.2.2 (d) (i))

Offside Rear Outer Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Sill (6.2.2 (d) (i))

Rear Position lamp not working Both (4.2.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Hazard switch flashing white

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting arch (6.2.2 (d) (i))

Windscreen washer provides insufficient washer liquid no water (3.5 (a))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced c post inside boot hatch (7.1.1 (a) (i))

Offside Front Drive shaft bent (6.1.7 (e))

Offside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength sub frame mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill next to axle mount (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

corrosion present on front cross member and chassis rails

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

no spare tyre

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Items removed from driver's view prior to test

both front suspension arm bushes worn

n/s/f inner anti roll bar bush showing signs of wear

o/s/f seat tilting mechanism defective

Items removed from driver's view prior to test

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

corrosion starting around drivers door edge

drivers seat tilting mechanism defective

n/s/f inner anti roll bar bush showing signs of wear

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Items removed from driver's view prior to test

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

corrosion starting around drivers door edge

drivers seat tilting mechanism defective

n/s/f inner anti roll bar bush showing signs of wear

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Headlamp aim too low (1.8)

Front Brake pad(s) wearing thin (3.5.1g)