2013 Keeway Tx 125

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pedal insecure cracked. (1.1.2 (e) (i))

Pillion seat insecure (6.2.6 (a) (ii)) DANGEROUS

Riders seat insecure (6.2.5 (a) (ii)) DANGEROUS

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust noisy (8.1.1 (a))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Headlamp aim not tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake excessively binding (1.2.1 (f))

Rear Brake pedal insecure split pin missing (1.1.2 (e) (i))

Rear reflector missing (4.8.2 (a) (ii))

Exhaust noisy (8.1.1 (a))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

o/s/f inner spindle locking bolt missing.

rear brake pad spring damaged.

Brake performance not tested rear brake fluid reservoir not connected lack of fluid (1.2.1 (g))

Drive chain excessively tight (6.1.7 (k) (i))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Front Brake cylinder insecure bolt missing (1.1.16 (c) (i))

Headlamp aim not tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake excessively binding (1.2.1 (f))

Rear Brake fluid reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Front Tyre has a lump or bulge caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Handlebar grip insecure to handlebar (2.2.1 (d) (ii)) DANGEROUS

Rear Brake cylinder leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Throttle control functioning such that safe operation of the motorcycle is adversely affected engine revving excessively on full right lock (6.2.7 (a) (ii)) DANGEROUS

Rear Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Wheel alignment slightly misaligned (2.4 (a))

side stand switch not attached and contacting chain

Rear Brake disc(s) has excessive run out (3.2.A1m)

Rear Drive chain excessively loose (6.2.1d)

Roller brake test No brake control achieves an efficiency of 30%. (3.3.A2a)

Nearside Front Direction indicators not working (1.5.1c)