2003 Hyundai Getz

Emissions not tested Emissions Test aborted due to Oil warning lamp flickering as fast idle started (8.2.1.2 (d))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Middle Sill Area (7.1.1 (a) (i))

Nearside Rear Body panel corroded and likely to cause injury Sharp edges Wheel Arch (6.2.1 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Seat belt not functioning as intended Does not retract (7.1.2 (c))

Offside Rear Body panel corroded and likely to cause injury Sharp edges Wheel Arch (6.2.1 (a) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer Sill Area (7.1.1 (a) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Subframe Heavily Corroded

Nearside Front Upper Oil leak, but not excessive Rocker area (8.4.1 (a) (i))

Offside Front Upper Small chip in windscreen

Offside Rear Body not fully secure Inner body and outer body panels not connected (Wheel Arch area) (6.2.2 (a) (i))

Offside Rear Lower Oil leak, but not excessive Sump bung area (8.4.1 (a) (i))

Offside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust has a minor leak of exhaust gases rear silenser (7.1.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

centre/rear exhaust corroded and holed

nearside rear seat belt clasp cover missing

offside front tyre worn inner edge

Front Shock absorber has a slightly reduced damping effect (2.7.5)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Front Brake pipe excessively corroded (3.6.B.2c)

Front Shock absorber has a slightly reduced damping effect (2.7.5)

Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Inner Brake pipe slightly corroded (3.6.B.2c)

Nearside Outer Brake pipe slightly damaged (2.2.D.2b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front registration plate insecure (6.3.1b)

Nearside Inner Brake pipe slightly corroded (3.6.B.2c)

Nearside Outer Brake pipe slightly damaged (2.2.D.2b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)