2004 Aprilia RS125

All direction indicators flashing less than 60 times a minute (4.4.4 (a))

rear suspension spongy in operation

All direction indicators flashing less than 60 times a minute (4.4.4 (a))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Headlamp not working on main beam (4.1.1 (a) (ii))

rear suspension spongy in operation

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Brake lever cannot be applied smoothly (3.1.3d)

Drive chain excessively loose (6.2.1d)

Front wheel bearings are excessively rough (2.3.5b)

Front wheel bearings have excessive free play (2.3.5b)

Headlamp aim not tested (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Indicator switch insecure (1.5.4)

Indicator tell tale not functioning (1.5.2)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear mono-shock pivot excessively worn (2.4.B.4)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Steering control fouling between components which interferes with the free movement of the steering (2.1.2a) DANGEROUS

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Offside Non obligatory mirror damaged ()

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Lower Rear mono-shock pivot worn but not excessive (2.4.B.4)

Rear Drive chain sprocket slightly worn (6.2.1e)

Rear both rear foot rests missing no rear seat fitted

Steering movement slightly 'notchy' (2.2.1b)

Upper Rear mono-shock pivot worn but not excessive (2.4.B.4)

Wheel alignment slightly misaligned. (2.5.1)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Footrest insecure both pivot have no lock to stop pin coming out (6.2.1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp switch faulty no main beam warning lamp on dash only on in dip mode (1.2.4)

Rear Brake disc(s) friction surface contaminated by oil or grease (3.2.A1k)

Rear Brake pad(s) contaminated by oil or grease (3.2.A1k)

Drive chain slightly loose (6.2.1d)

Drive chain worn but not considered excessive (6.2.1e)

Lower Rear mono-shock pivot worn but not excessive (2.4.B.4)

Rear Drive chain sprocket slightly worn (6.2.1e)

Steering movement slightly 'notchy' (2.2.1b)

Upper Rear mono-shock pivot worn but not excessive (2.4.B.4)

Wheel alignment slightly misaligned. (2.5.1)

Rear Brake disc(s) slightly scored (3.2.A1l)

Front Dipswitch does not extinquish main beam/s, leaving at least 1 dipped beam headlamp (1.2.2b(i))

Front Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Registration plate with character(s) which are not the correct height (6.3.4a)

Drive chain excessively loose (6.2.1d) DANGEROUS

Rear Tyre not fitted in accordance with side wall instruction/s (4.1.2e) DANGEROUS

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear wheel bearings have slight free play (2.4.A.2c)

rear cush drive worn? rubbers?

Rear Brake master cylinder slightly damaged (3.2.B1b)

Nearside Rear Footrest missing (6.2.1a)

Offside Front Footrest insecure (6.2.1a)

Offside Rear Footrest missing (6.2.1a)

Rear Roller brake test indicates brake effort fall disproportional to brake lever or pedal effort (3.3.A1c)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)