2005 Fiat Ducato

Exhaust corroded

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced out rigger (6.1.1 (c) (i))

Offside Front Headlamp aim too far to the right (4.1.2 (a))

Offside Rear Inner Tyre has a bulge, caused by separation or partial failure of its structure side wall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Horn not working (7.7 (a) (ii))

Nearside Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced within 30cm of engine mount (6.1.1 (c) (i))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Lower Outline marker lamp not working (4.2.1 (a) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

front cross member corroded

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner seal / jacking point (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner seel / chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner seel / chassis (5.3.6 (a) (i))

radiator support / cross member corroded

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner seal / jacking point (5.3.6 (a) (i))

Nearside Rear Outline marker lamp not working (4.2.1 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner seel / chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner seel / chassis (5.3.6 (a) (i))

radiator support / cross member corroded

Front Lower Suspension component mounting prescribed area is corroded but not considered excessive cross member (2.4.A.3)

Power steering pipe(s) or hose(s) slightly corroded steering rack pipe (2.3.2)

front cross member corroded

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure sidewall spiltting 215/70/r15c (4.1.D.1b)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure sidewall splitting (4.1.D.1b)

Nearside Headlamp aim too low (1.8)

Offside Front Suspension component mounting prescribed area is excessively corroded near jacking point mounting (2.4.A.3)

Offside Headlamp aim too low (1.8)

Service brake: efficiency below requirements (3.7.B.7)

Power steering pipe(s) or hose(s) slightly corroded steering rack pipes (2.3.2)

front cross member coroded

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Nearside Suspension component mounting prescribed area is excessively corroded Front inner wing section near brake flex mounts (2.4.A.3)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement Rear bush (2.4.G.2)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Rear Direction indicator not working (1.4.A.2c)

Offside Rear fog lamp not working (1.3.2b)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Horn not working (1.6.2a)