2008 Ford Ka

Exhaust mounts are corroded

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases Flexi (6.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Exhaust mounts are corroded

Nearside Front Brake hose slightly twisted (1.1.12 (b) (i))

Exhaust mounts are corroded

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Inner Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner and outer sill (5.3.6 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Exhaust mounts are corroded

Front brake pads approx 80% worn

Reverse light not working

Hazard warning switch faulty (4.4.2 (a) (i))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Hazard warning switch faulty (4.4.2 (a) (i))

Hazard warning switch faulty switch cover (4.4.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Bumper insecure (6.1.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Coil spring fractured or broken rubbing tyre (5.3.1 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Hazard warning switch faulty switch cover (4.4.2 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

coolant bottle empty

exhaust welded

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Suspension arm pin or bush excessively worn axle bush worn (5.3.4 (a) (i))

Nearside Track rod end modification unsafe split pin missing lock device (2.1.3 (f) (i))

Offside Rear Suspension arm pin or bush excessively worn axle bush worn (5.3.4 (a) (i))

Offside Track rod end modification unsafe split pin missing lock defice (2.1.3 (f) (i))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

exhaust welded

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Sub-frame has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Rear registration plate deteriorated (6.3.1d)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Lower Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Wheel alignment needs adjusting

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS