2008 Mazda RX-8

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Chassis slightly corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin front pads getting low 70% approx. (3.5.1g)

rear silencer to middle pipe clamp completely corroded so it's not holding the exhaust tight, but it is preventing the leak of exhaust gases

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear brake discs corroded,but not seriously weakened.

Under-trays fitted obscuring some underside components

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage fractured (2.4.G.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)