2003 Rover 25

Front Brakes imbalanced across an axle offside slow to operate (1.2.1 (b) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Front coil spring corroded both (2.4.C.1b)

Rear Brake hose has slight corrosion to ferrules both sides (3.6.B.4e)

Front coil spring corroded (2.4.C.1b)

Offside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

NSR Tyre Perishing

Power steering component(s) has slight seepage from a component (2.3.3b)

Nearside Headlamp aim too low (1.8)

nsr tyre begining to show cracks in tread pattern

nsr tyre begining to show cracks in tread pattern

Offside Stop lamp not working (1.2.1b)

Centre Stop lamp not working (1.2.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)