2009 Hyundai I10

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength Adjacent to suspension arm mounting point (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Side repeater not working (4.4.1 (a) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Service brake grabbing severely (1.2.1 (c))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Front brake balance uneven but within limits

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Brake pad(s) wearing thin advise replace 2 to 3 k (1.1.13 (a) (ii))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

both front tyres 2mm on edges

high level brake light inop

Centre Stop lamp not working (1.2.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Stop lamp not working (1.2.1b)