2012 Toyota Hilux

Nearside Front Headlamp lens slightly defective faded (4.1.1 (b) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sill corroded (6.1.1 (c) (i))

Nearside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced chassis corroded (6.1.1 (c) (i))

Central Prop shaft bearing has slight play (6.1.7 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material Along axle (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material To loads sensor valve (1.1.11 (c))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Along chassis rails (6.1.1 (c) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material Along axle (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material To load sensor valve (1.1.11 (c))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Along chassis rails (6.1.1 (c) (i))

Offside Rear Underside body back corrosion

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Emissions unable to be completed Silencer missing (8.2.2.2 (e))

Rear Exhaust has a major leak of exhaust gases Missing silencer (6.1.2 (a))

Central Prop shaft bearing has slight play (6.1.7 (b) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material Along axle (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material To loads sensor valve (1.1.11 (c))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Along chassis rails (6.1.1 (c) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material Along axle (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material To load sensor valve (1.1.11 (c))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Along chassis rails (6.1.1 (c) (i))

Offside Rear Underside body back corrosion

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Worn edges (5.2.3 (e))

Rear Tyre worn close to legal limit/worn on edge Both 2mm (5.2.3 (e))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Registration plate inscription illegible (0.1 (b))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge Worn edges (5.2.3 (e))

Rear Tyre worn close to legal limit/worn on edge Both 2mm (5.2.3 (e))

Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

emissions too clean to read k=0.00

parking brake lever has travel

Parking brake has little reserve travel

Parking brake has little reserve travel

Windscreen washer provides insufficient washer liquid (3.5 (a))