2007 Ktm 250 Exc-f

Front Wheel bearing has slight play (5.1.3 (a) (i))

side stand slightly loose

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front slight noise/roughness in wheel bearing

Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Rear Wheel spoke slightly loose (5.2.2 (d))

Stop lamp light intensity obviously reduced (4.3.3 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front slight roughness in wheel bearing

Rear Wheel spoke slightly loose (5.2.2 (d))

Front Tyre is unsuitable Not for road use (5.2.3 (a))

Registration plate does not conform to the specified requirements (0.1 (d))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Drive chain sprocket worn, but not excessively (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Exhaust noisy (8.1.1 (a))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Suspension arm ball joint worn, but not excessively Play in swing arm bearings (5.3.4 (a) (i))

Front Tyre is unsuitable not Emarked- n.h.s sanded off (5.2.3 (a))

Offside Handlebar fouling on the fuel tank or bodywork on full lock steering stop missing (2.1.4 (b))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Brake fluid reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Front Horn missing (1.7.1)

Rear Rear reflector on motorcycle missing (1.4.1)

Rear Registration plate margin less than the minimum requirement (6.3.4g)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)