2006 Toyota Aygo

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Non obligatory mirror damaged

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides sills (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced various spots (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Non obligatory mirror damaged

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides sills (6.2.2 (d) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced various spots (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Horn weak

Lower Gearbox mounting defective

Stop lamp(s) non-obligatory stop lamp not working high level brake (4.3.1 (a) (ii))

vehicle has been under sealed

Front Exhaust mounting defective (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounts on both sides (5.3.6 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive suspension parts (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive sills and floor (5.3.6 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive suspension parts (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive sills and floor (5.3.6 (a) (i))

Front Service brake fluctuating, but not excessively both (1.2.1 (e))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Road wheel fixing missing (5.2.1 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Offside Front Inner Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Rear Shock absorber has slight corrosion to the casing both (2.7.2a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Front Inner Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement rear bush (2.4.G.2)

Rear Shock absorber has slight corrosion to the casing both (2.7.2a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm 0.5mm (4.1.E.1)

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm 1.4mm (4.1.E.1)

Bonnet Release Insecure

N/S/F Side Repeater Lens Broken

Nearside Rear Nail in tyre

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Indicator switch faulty (1.4.A.1)

Nearside Front Headlamp aim too high (1.8)

Registration plate lamp not working both rear (1.1.C.1d)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)