1998 Rover 416

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

O/s/r tyre on inner edge tread slightly uneven.

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

heat sheild insecure on catalytic converter

o/s/r tyre is slightly uneven in tread on inner edge

advise o/s/r tyre wearing unevenly

Nearside Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Offside Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

advise o/s/r tyre wearing unevenly

Brakes imbalanced across an axle (3.7.B.5b)

Offside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside front brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside front brake binding (3.7.B.1)

front brakes release unevenly (3.7.B.4)

registration plate deteriorated (6.3.1d)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Nearside Lower Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

both no.plates poor condition

ns rear foot & handbrake performances slightly low

Nearside Lower Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

both no.plates poor condition

ns rear foot & handbrake performances slightly low

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Front position lamp(s) not in good working order (function impaired) (1.1.4a)

Offside Rear Stop lamp not working (1.2.1b)