1998 Vauxhall Combo

Battery insecure (1.9.1)

Body has a sharp edge caused by corrosion (6.1.C.1)

Body has a sharp edge caused by corrosion (6.1.C.1)

Body has a sharp edge caused by damage (6.1.C.1)

Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt locking mechanism does not secure or release (5.2.5a)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Corrosion on underside of van

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake discs and pads worn

Front bumper damaged

Front cross member corroded and bent out of shape

O/S Steering rack boot wet - posible oil leak from steering rack

Offside Rear Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Oil leak

bodywork poor condition

bonnet slightly corroded

engine noisey

front coil springs slightly corroded

n/s/r tyre worn on outter edge

o/s/f outter sill slightly corroded

o/s/r tyre worn on outter edge

rear chassis corroded outside of perscribed area

slightly exhaust blow

underside of vehicle slightly corroded

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear An item not tested (Manual)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside rear brake binding (3.7.B.1)

engine noisey

Oil leak

bodywork poor condition

bonnet slightly corroded

front coil springs slightly corroded

n/s/r tyre worn on outter edge

o/s/f outter sill slightly corroded

o/s/r tyre worn on outter edge

rear chassis corroded outside of perscribed area

slightly exhaust blow

underside of vehicle slightly corroded

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has part of the system excessively deteriorated (7.1.1a)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate deteriorated (6.3.1d)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

NSF TYRE ON LIMIT

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

bonnet safety catch pivot seized

Front Mechanical brake component securing device loose (3.5.1i)

Nearside Outer Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Loading door cannot be secured in the closed position (6.4.1)

Offside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

bonnet safety catch pivot seized

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Offside Lower Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt pre-tensioner has been activated

handbrake cable mounting weak

Nearside rear brake grabbing severely (3.7.A.5b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)

Offside Lower Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt pre-tensioner has been activated

handbrake cable mounting weak

as tested

Hazard warning tell tale not working correctly (1.4.B.1e)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Seat belt locking mechanism does not secure or release (5.2.5a)

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Steering system has a tyre fouling a part of the vehicle (2.2.D.2a)

clunk on rotation of os front wheel in reverse - probably driveshaft

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)