1998 Rover 420

Centre Brake pipe excessively corroded (3.6.B.2c)

Front registration plate deteriorated (6.3.1d)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Brake pipe leaking (3.6.A.1)

Nearside Rear Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim too high (1.8)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Brake pipe kinked (3.6.B.2b)

Offside Rear Radius arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate deteriorated (6.3.1d)

Service brake: efficiency below requirements (3.7.B.7)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Oil leak

Rear wiper split

Brake master cylinder fluid close to minimum level (3.6.G.1e)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

both rear wheel arches starting to corrode

front and rear number plates starting to deteriorate

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.6.D2)

Nearside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Windscreen wiper blade deteriorated (8.2.2)

Offside Headlamp aim too low (1.6.D2)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Windscreen wiper blade deteriorated (8.2.2)

Registration plate lamp not working (1.1.5c)