1998 Suzuki GSX600

Front Brake indicates a slightly grabbing brake (1.2.1 (c))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Front Brake indicates a slightly grabbing brake (1.2.1 (c))

Rear Brake indicates a slightly grabbing brake (1.2.1 (c))

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Horn not working (1.7.3a)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Rear Tyre worn close to the legal limit (4.1.3(ii))

bodywork damage/corrosion/front/rear tyre near limit CENTRE

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake pedal is bent but brake can still be readily applied (3.1.3c)

bodywork/light damage 0/s front outer framework/chain DRY/RUSTY/rear no.plate disc/ballend MISSING clutch lever REPLACE/side stand sticky free off /lub/swing arm rusty covered in oil/clean off

slight BIND rear wheel REQ STRIP/CLEAN

slight BIND rear wheel REQ STRIP CLEAN

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

slight BIND rear wheel REQ STRIP CLEAN

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Exhaust slightly deteriorated (7.1.1a)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp aim too low (1.6)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)