1998 Ford Transit

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen wiper blade defective (3.4 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Hazard warning lamps inoperative Not working O/S front, rear or side repeater (4.4.1 (e))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Lower arm mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Shocker mount (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Central Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive Top mount (5.3.6 (a) (i))

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced Top side (6.1.1 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Shock mount (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced Step area (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive Chassis leg (5.3.6 (a) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive Top mount (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Oil leak, but not excessive Gear box (8.4.1 (a) (i))

Oil leak, but not excessive Rear diff (8.4.1 (a) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened offside and nearside , outer face of disc (1.1.14 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive top strut mount (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened offside and nearside , outer face of disc (1.1.14 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive top strut mount (5.3.6 (a) (i))

Central Upper Oil leak, but not excessive rear gearbox oil seal (8.4.1 (a) (i))

Nearside Front Upper Vehicle structure is corroded but structural rigidity is not significantly reduced inner wheel arch (6.1.1 (c) (i))

Nearside Rear Upper Brake actuating linkage mounting prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive shock absorber (5.3.6 (a) (i))

Central Prop shaft bearing excessively worn (6.1.7 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Exhaust has a major leak of exhaust gases flexi section (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross-member (5.3.6 (a) (i))

Offside Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross-member (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin check in 3000 miles (1.1.13 (a) (ii))

Nearside Front Upper Suspension component mounting repair covered in underseal shock absorber mounting area (5.3.6 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis leg shock mounting (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive shock absorber mounting area (5.3.6 (a) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis leg shock mounting area (5.3.6 (a) (i))

Front Exhaust has a minor leak of exhaust gases Flexi (6.1.2 (a))

Front Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive Top shock absorber mounts (5.3.6 (a) (i))

Front crossmember corroded

Tyre slightly damaged/cracking or perishing all four (5.2.3 (d) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front crossmember corroded

Tyre slightly damaged/cracking or perishing all four (5.2.3 (d) (ii))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Upper Inner wing starting to corrode by strut top

Nearside Rear Sill corroded

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Brake pedal anti-slip provision missing (1.1.2 (c))

Offside Front Inner Cab steps in such a condition that it is likely to cause injury As marked (6.2.8 (b))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Next to chassis near cab step as marked (6.2.2 (d) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Upper Inner wing starting to corrode by strut top

Nearside Rear Sill corroded

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Cab steps insecure Step/inner sill corroded ( looks like the inner step has been replaced ) (6.2.8 (a) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive shocker plate (5.3.6 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive shocker plate (5.3.6 (a) (i))

Prop shaft bearing has slight play (6.1.7 (b) (i))

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside rear brake fluctuating, but not excessively (3.7.B.3)

tail pipe deterating

Brake pedal anti-slip provision missing (3.3.A.1b)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper blade insecure (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear rear brake juddering severely (3.7.A.5b)

Parking brake lever is impeded in its travel (3.1.6c)

rear brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Vehicle structure has slight corrosion (6.1.A.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

rear brake application uneven (3.7.B.2)

rear brake grabbing severely (3.7.A.5b)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

nearside front tyre has a cut but not in excess of the requirements to reach the ply or cords

second battery not secure under bonnet

Nearside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

SECOND BATTERY NOT SECURE IN TRAY

Offside Front brake disc excessively pitted (3.5.1h)