2009 Ford Freda

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Battery insecure but not likely to fall from carrier both sides (4.13 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting 2 inner sill (6.2.2 (d) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting by inner sill (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch (6.2.2 (d) (i))

Front Battery insecure but not likely to fall from carrier both sides (4.13 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Suspension component corroded but not seriously weakened gearbox mounting (5.3.3 (b) (i))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cross member under radiator (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under wing 2 places (5.3.6 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill near rear suspension mounting (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill near rear suspension mounting (5.3.6 (a) (i))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Seat belt anchorage prescribed area is corroded but not considered excessive both rear under wheel arches near seat belt mountings no seats fitted (7.1.1 (a) (i))

Suspension component corroded but not seriously weakened gearbox mounting (5.3.3 (b) (i))

Nearside engine mount corroded

Rear Coil spring corroded both (5.3.1 (b) (i))

general heavy corrosion front to rear

rear wheel arches corroded

Central Exhaust has a major leak of exhaust gases flex joint (6.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer cills (7.1.1 (a) (i))

Nearside Headlamp incorrect colour (4.1.4 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer cills (5.3.6 (a) (i))

Nearside Rear Upper Shock absorbers insecurely attached (5.3.2 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner and outer cills (7.1.1 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer cills (5.3.6 (a) (i))

Offside Rear Upper Shock absorbers insecurely attached (5.3.2 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside engine mount corroded

Rear Coil spring corroded both (5.3.1 (b) (i))

general heavy corrosion front to rear

rear wheel arches corroded

rear seats not fitted at time of test

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced on cross member in two places (6.1.1 (c) (i))

Front Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Front Drive shaft joint constant velocity boot missing (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Anti-roll bar pin or bush excessively worn both (5.3.4 (a) (i))

rear seats not fitted at time of test

Nearside Front Headlamp light intensity severely reduced fault when main beam applied (4.1.4 (a))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Service brake lagging in operation (1.2.1 (d))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Shock absorber has slight corrosion to the casing Both sides (2.7.2a)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Stop lamp not working (1.2.1b)

Rear Shock absorber has slight corrosion to the casing Both sides (2.7.2a)

Front Subframe mounting prescribed area is excessively corroded cross member (2.4.A.3)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement d bush (2.4.G.2)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded inner arch (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner arch (2.4.A.3)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement d bush (2.4.G.2)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside front brake binding (3.7.B.1)

Rear Exhaust has a major leak of exhaust gases silencer (7.1.2)

Front Inner brake disc worn, pitted or scored, but not seriously weakened slightly corroded (3.5.1i)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

middle brake light not working

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner and outer sill (2.4.A.3)

Offside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner and outer sill (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

cannot check rear seatbelts as matteress down

nearside front tyre starting to crack in the tread

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

cannot check rear seatbelts as matteress down

nearside front tyre starting to crack in the tread

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

rear chassis corroded and holed