1998 Mazda Bongo

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Horn not working (7.7 (a))

Nearside Front Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect Headlamp too misty (4.1.2 (c))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases Flexy (6.1.2 (a))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Vehicle under-sealed + front sub-frame heavily corroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Emissions not tested (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak centre to rear flange (8.2.1.1 (b))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Rear Anti-roll bar linkage pin or bush excessively worn both (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill (5.3.6 (a) (ii)) DANGEROUS

rear heat shield insecure and sitting on back box

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement bush worn/ and partly out [requires attention] (5.3.4 (a) (i))

Offside tail lamp cluster cracked

Vehicle structure is corroded but structural rigidity is not significantly reduced body sill at offside (6.1.1 (c) (i))

bonnet stay missing

reverse lights not working

Emissions not tested (8.2.1.2 (d))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch missing (4.5.3 (a) (ii))

Spare tyre defective flat ()

n/s front sill holed due to corrosion but not within 30cm of a prescribed area

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced 2 points of N/S/R sill has excessive corrosion causing a hole at 2 points. (6.1.1 (c) (i))

Front front brakes binding when rotated by hand.

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Child Seat fitted not allowing full inspection of adult belt ()

bonnet stay missing

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Offside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

all tyres worn on inner and outer edges

both rear tyres near limit

Nearside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Rear fog lamp not working (1.3.2b)

all tyres worn on inner and outer edges

both rear tyres near limit

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Front Brake pad(s) wearing thin (3.5.1g)

NO REAR SEATS FITTED WHEN TESTED

Nearside Headlamp aim too high (1.8)