1997 Honda Civic

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside and nearside outer sill,inner sill wheel arches (5.3.6 (a) (i))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Front Registration plate incorrect (0.1 (c))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Exhaust has a minor leak of exhaust gases middle (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

rear bumper not secure

under body slightly rust

Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc both side (2.5.C.1a)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Exhaust has a minor leak of exhaust gases middle (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

rear bumper not secure

under body slightly rust

Front Exhaust has a minor leak of exhaust gases system rusted generally (7.1.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill-end/under-sill rusted (2.4.A.3)

Offside Front tyre sidewall cracking

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill-end/under-sill rusted (2.4.A.3)

outer-sill covers fitted

both sides rear wheel-arch bottoms to sills rusted

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Rear Body has slight corrosion (6.1.B.2)

near side front tyre got cut but not deep enough to cause sepration in wall

Offside Rear Body has slight corrosion (6.1.B.2)

near side front tyre got cut but not deep enough to cause sepration in wall

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

n/s/r and o/s/r tyres wearing low

o/s/r tyre wearing low on inner edge