1998 Subaru Impreza

Brake pedal anti-slip provision missing (1.1.2 (c))

Horn not working (7.7 (a) (ii))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/floor pan (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill/floor pan (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Seat belt missing all rear (7.1.2 (a))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Nail in tyre ()

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nail in nearside rear tyre

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Registration plate lamp not working (1.1.5c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Offside Front Steering column shaft has slight end float (2.1.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)