1998 Ktm Duke 620

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Position lamp not working (4.2.1 (a))

no plate slightly smaller than normal but still readable from the required distance.

Headlamp aim too low (1.6)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Front Tyre worn close to the legal limit (4.1.3(ii))

front tyre wearing unevenly.

no plate slightly smaller than normal but still readable from the required distance.

Offside Wheel alignment slightly misaligned. (2.5.1)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

no plate alittle smaller than normal but still readable from required distance.

Drive chain excessively loose (6.2.1d)

Fuel cap sealing washer torn (7.2.2c)

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Steering movement excessively 'notchy' with the weight on the lower bearing (2.2.1a)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Offside Wheel alignment slightly misaligned. (2.5.1)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

no plate alittle smaller than normal but still readable from required distance.

rear brake pad pin locking device incorrectly fitted.

relay switchs inside front headlight assembly not secured and could prevent steering from turning fully.

temp warning light does not go out and cooling fan not coming on.

Front Brake lever is so short and the brake cannot be readily applied (3.1.3c)

Front Tyre worn close to the legal limit (4.1.3(ii))

Fuel cap sealing washer missing (7.2.2c)

Nearside Handlebar mounting clamp bolt loose (2.1.1a)

No plate alittle smaller than normal but still readable from required distance

Offside Handlebar mounting clamp bolt loose (2.1.1a)

Rear reflector on motorcycle missing (1.4.1)

non standard muffler fitted, alittle louder than orignal one but not excessively so

relay unit loose behind headlight assembly but not affecting steering in any way

Front Tyre worn close to the legal limit (4.1.3(ii))

No plate alittle smaller than normal but still readable from required distance

non standard muffler fitted, alittle louder than orignal one but not excessively so

relay unit loose behind headlight assembly but not affecting steering in any way

Exhaust noisy (7.1.2)

Rear suspension bearing has slight free play (2.4.A2a(i))