1998 Rover 420

Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

NOTE; unable to fully inspect welding repairs to both rear sill as have been coated in underseal & fiber glass

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front to rear fuel pipes are heavily corroded

o/s track rod end dust cover is split

oil leak on/around engine

oil level below min mark

power steering fluid resevoir appears to be slight damp , as do the pipes to and from the resevoitr--possible spillage / slight seepage

rear wheel arches starting to corrode may soon need attention

temp repair to rear bumper

Body has a sharp edge caused by damage (6.1.C.1)

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.0)

Exhaust system not adequately supported (7.1.1)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

oil level below min mark

Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front to rear fuel pipes are heavily corroded

n/s wing mirror missing

o/s track rod end dust cover is split

oil leak on/around engine

power steering fluid resevoir appears to be slight damp , as do the pipes to and from the resevoitr--possible spillage / slight seepage

rear wheel arches starting to corrode may soon need attention

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

n/s wing mirror not fitted

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

n/s wing mirror not fitted

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

n/s mirror assembly missing

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

n/s wing mirror assembly missing

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak