1997 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner wheel arch (7.1.1 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner wheel arch (7.1.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Front Lower Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Play in steering rack inner joint(s) Both ()

Rear Exhaust mounting defective Rubber splitting (6.1.2 (a))

Nearside Front Windscreen damaged but not adversely affecting driver's view small chip in screen (3.2 (a) (i))

all suspension bushes split but no play

front & rear subframe corroded

front suspension arms corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Windscreen damaged but not adversely affecting driver's view small chip in screen (3.2 (a) (i))

all suspension bushes split but no play

front & rear subframe corroded

front suspension arms corroded

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

*vehicle over heated during test*

Anti-roll bar pin or bush worn but not resulting in excessive movement all (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Fuel Pipe/s corroded ()

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

corrosion throughout vehicle

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Shock absorbers insecurely attached bottom bolt loose (5.3.2 (a) (i))

Nearside Rear Shock absorbers insecurely attached bottom bolt loose (5.3.2 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Shock absorbers insecurely attached top nut missing, and bottom bolt loose (5.3.2 (a) (i))

Offside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

*vehicle over heated during test*

Anti-roll bar pin or bush worn but not resulting in excessive movement all (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Fuel Pipe/s corroded ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

corrosion throughout vehicle

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement all perished but no movement (5.3.4 (a) (i))

Offside Obligatory mirror slightly loose (3.3 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Tyre slightly damaged/cracking or perishing both front inner walls (5.2.3 (d) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

heavy surface corrosion on subframes and suspension arms

Fuel Pipe/s corroded ()

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Brake pad(s) wearing thin (3.5.1g)

heavy surface corrosion underneath

Electrical wiring damaged, likely to cause a short lambda wire melting on exhaust (1.9.2b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Rear Brake pipe excessively corroded across axle (3.6.B.2c)

Fuel Pipe/s corroded ()

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Brake pad(s) wearing thin (3.5.1g)

heavy surface corrosion underneath

exhaust trim loose

Front Brake pad(s) wearing thin (3.5.1g)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt anchorage prescribed area is corroded but not considered excessive both (5.2.6)

Centre Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working both (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt anchorage prescribed area is corroded but not considered excessive both (5.2.6)

exhaust trim loose

Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

all suspension arm bushes showing signs of perishing

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low and too far to the right. (1.8)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front and rear axles rusted but solid

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front and rear axles rusted but solid

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front front brake binding (3.7.B.1)

Oil leak

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Rear Direction indicator not working (1.4.A.2c)

condition of both rear discs

n/s/f brake binding slightly

n/s/r pad wearing

very sligth blow from exhaust

corrosion to main brake pipe from front to rear borderline

corrosion under vehicle

underseal to brake pipes inpsection limited