1998 Ford Ka

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel pipe/s corroded

Oil leak

Rear Brake pipe slightly corroded (3.6.B.2c)

Underbody corroded

Front Brake pad(s) wearing thin (3.5.1g)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Outer Front Body has a sharp edge caused by corrosion (6.1.C.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front coil spring corroded (2.4.C.1b)

Centre Rear Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Centre Rear Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front coil spring corroded (2.4.C.1b)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high and too far to the left. (1.8)

Offside Outer Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)