1997 Mazda Bongo

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis rail (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Outer CV boot deteriorated

Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material both fronts (1.1.11 (c))

General underside corrosion

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outrigger (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

vehicle undersealed in various places

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn d bush (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch / bumper area (5.3.6 (a) (i))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced various places (6.1.1 (c) (i))

vehicle undersealed in various places

Nearside Front sill corroded

Nearside Rear sill corroded

Vehicle structure is corroded but structural rigidity is not significantly reduced various spots (6.1.1 (c) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Corrosion to floor pan and chassic

n/s/f sill badly corroded

n/s/r sill badly corroded

slight leak from n/s/f c.v gaiter

general underside corrosion to components including, floor pans, sills and suspension

slight leak from nearside CV boot

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Central Exhaust has a minor leak of exhaust gases (7.1.2)

general underside corrosion to components including, floor pans, sills and suspension

slight leak from nearside CV boot

rear exhaust box deteriorated

all brake discs corroded

front and rear brake discs pitted

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

abs unit not seen

both front tyres unevenly worn

engine not seen

exposed live wire under bonnet

Nearside Headlamp aim too high (1.8)

Nearside Inner Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Statutory seat belt missing (5.1.1)

Offside Headlamp aim too high (1.8)

Offside Inner Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

abs unit not seen

both front tyres unevenly worn

engine not seen

exposed live wire under bonnet