1998 Renault Kangoo

Brake pipe slightly corroded (3.6.B.2c)

Gearbox mounting defective

Nearside Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside rear brake juddering slightly (3.7.A.5b)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Parking brake lever has little reserve travel (3.1.6b)

Play in steering rack inner joint(s)

Engine/gearbox mounting(s) defective

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Rear Brake pipe slightly corroded (3.6.B.2c)

offside inner door handle missing,however a cable tie has been connected to inside release rod,door can be opened from inside, would recommend replacing.

Driver's door cannot be opened from inside the vehicle (6.2.B.1b)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front constant velocity joint is slightly worn (2.5.C.1b)

Brake load sensing valve linkage seized (3.6.E.3)

Exhaust system not adequately supported (7.1.1)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Spare wheel carrier insecure (6.4.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear brake application uneven (3.7.B.2)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Stop lamp not working (1.2.1b)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front coil spring incomplete (2.4.C.1a)

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front coil spring incomplete (2.4.C.1a)

Offside Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Registration plate lamp not working (1.1.5c)

Windscreen washer provides insufficient washer liquid (8.2.3)