1998 Kawasaki ZX6R

Drive chain worn to excess Chain has seized sections (6.1.7 (c) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp lens seriously defective Headlamp is incorrectly fitted to the housing (4.1.1 (b) (ii))

Horn not working (7.7 (a))

Nearside Front Wheel excessively damaged Front wheel is buckled (5.2.2 (c) (i))

Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Rear reflector missing (4.8.2 (a) (ii))

Rear Registration plate inscription illegible Number plate not complete (0.1 (b))

Steering operation restricted in free movement from lock to lock Wiring loom catching on full lock (2.1.4 (c))

Front Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front brake lines have ben covered with insulation tape, unable to fully check the condition

OSR wheel adjuster locking nut is loose

Exhaust has a minor leak of exhaust gases exhaust leaking slightly at header pipe area (6.1.2 (a))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Shock absorber has a light misting of oil (5.3.2 (b))

Front Brake disc(s) is excessively distorted (3.2.A1m)

Horn control defective (1.7.2a)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Chain guard insecure (6.2.1c)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Brake master cylinder fluid level dangerously low (3.2.B1d)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Exhaust is leaking but is not excessively noisey (7.1.1b)

Front Exhaust slightly deteriorated (7.1.1a)

Front Roller brake test indicates a severely juddering brake (3.3.A1b)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Nearside Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Offside Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Nearside Front Brake disc(s) has slight run out (3.2.A1m)

Offside Front Brake disc(s) has slight run out (3.2.A1m)

brakes binding front