1997 Mazda Bongo

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Offside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Brake master cylinder below minimum mark (1.1.10 (d) (i))

Nearside Front Brake pipe corroded, covered in grease or other material at abs pump (1.1.11 (c))

Nearside Front Oil leak, but not excessive driveshaft seal (8.4.1 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside inner sill area

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material or main (1.1.11 (c))

underside of vehicle covered in underseal

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Oil leak, but not excessive shaft seal (8.4.1 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Underbody Covered In Underseal

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Oil leak, but not excessive shaft seal (8.4.1 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Underbody Covered In Underseal

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Oil leak, but not excessive Diff Shaft Seal (8.4.1 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

heavily under sealed

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis - next to subframe mount front side & Rear Side (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis - next to subframe mount front side & Rear Side (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Oil leak, but not excessive Diff Shaft Seal (8.4.1 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

heavily under sealed

Front cross-member

Suspension component mounting repair covered in underseal Complete under-side of vehicle (5.3.6 (a) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Arch (5.3.6 (a) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Sill (7.1.1 (a) (i))

Offside Rear Inner Vehicle structure excessively corroded within 30cm of towbar mounting Sill (6.1.6 (i) (i))

Front cross-member

Suspension component mounting repair covered in underseal Complete under-side of vehicle (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front crossmember corroded

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake repair covered in underseal (1.1.21 (e) (i))

Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Suspension spring mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill outer and inner (6.1.1 (c) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

excessive corroded underneath surface corrosion every where

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Fuel cap/sealing device missing (7.2.4a)

Horn not working (1.6.2a)

Nearside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

leak coming from gearbox oil cooler pipe

Front crossmember corroded

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear engine mounting bracket corroded

general corrosion underneath vehicle

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp does not operate immediately when selected on dipped beam (1.7.4a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear fog lamp not working (1.3.2b)

Service brake juddering severely (3.7.C.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Anti-roll bar ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Child seat fitted not allowing full inspection of adult belt

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)