1998 Rover 620

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Front Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Offside Rear Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Play in steering rack inner joint(s) ()

Offside Rear Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Fuel Pipe/s corroded ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner sill (6.2.2 (d) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen washer provides insufficient washer liquid Both (3.5 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both inner sill (6.2.2 (d) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

general body corrosion.

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

general body corrosion.

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Obligatory mirror is incapable of being adjusted to provide an adequate view to the rear (8.1.2b)

Rear fog lamp not working (1.3.2b)

Front All position lamps not working (1.1.A.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too high and too far to the left. (1.8)

Offside Rear All position lamps not working (1.1.A.3b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Track rod end ball joint has slight play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Inner Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Parking brake lever has little reserve travel (3.1.6b)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Non obligatory mirror damaged

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Nearside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Service brake: efficiency below requirements (3.7.B.7)