1997 Ford Freda

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x member (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced below seat (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength x member (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

inner sills plated and undersealed

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill floor (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Front Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

several areas on underside plated and undersealed

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

several areas on underside plated and undersealed

Emissions not tested device stopping exhaust probe (7.4.B.1)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Parking brake: efficiency below requirements (3.7.C.1b)

Service brake juddering severely (3.7.C.2)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside sill corroded and masked with Glass Fibre

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

rear wiper blade split

Rear fog lamp not working (1.3.2b)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear wiper blade split

Nearside Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar attachment bracket/mounting damaged and its strength is seriously reduced (2.4.G.1)

Nearside Stop lamp not working (1.2.1b)

Offside Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Centre Rear Seat belt has a cut which has significantly weakened the webbing (5.2.2a)

Offside Outer Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Windscreen wiper blade deteriorated (8.2.2)

Offside Windscreen wiper blade deteriorated (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.C.1b)