1998 Ford Ka

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Steel brake pipes hevilly underseald.

Underside heavilly corroded.

Underside heavilly underseald.

Brakes imbalanced across an axle (3.7.B.5b)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Fuel cap/sealing device mounting flange/sealing method defective (7.2.4c)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Brake hose slightly deteriorated (3.6.B.4d)

Offside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

battery insecure

brake pipes covered in ubnderseal unable to inspect

front discs in poor condition

front exhaust clamp broken

n/s/f cv boot has small nleak of grease

n/s/f floor to sill areas corroded and has privious repairs all heavily under sealed

n/s/f lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement

n/s/f tyre near bald on outside edge

n/s/r and o/s/r boot floor excessivly corroded and holed

n/s/r axel bush has slight play

o/s/f floor to sill areas corroded and has privious repairs all heavily under sealed

o/s/f tyre has cut in outer side wall

o/s/r chassis leg corroded and heavily repaired and under sealed

rear brake imbalance 30%

BOTH FRONT DISCS RUSTY

UNDERBODY BEEN WELDED AND UNDERSEALED SEEMS OK

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Body has slight corrosion (6.1.B.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Rear coil spring fractured (2.4.C.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Body has slight corrosion (6.1.B.2)

Both rear trailing arm bushes worn but not excessive

Slight exhaust leak at cat join

Slight leak on inlet manifold

Slight play in both front antiroll bar bushes

Slight play in steering rack

Steering column UJ worn

Vehicle has corrosion welding carried out along both sills

Hazard warning switch missing (1.4.B.1d)

Indicator switch faulty (1.4.A.1)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear wheel bearing has excessive play (2.6.2)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Vehicle has corrosion welding on underside of vehicle

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Obligatory mirror insecure (8.1.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Boot floor to rear panel corroded.

Both front brake discs corroded.

Both rear tyres low.

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Play n/s steering rack on limit.

Rear view mirror loose.

Slight play o/s/r hub.

Steering column uj worn.

o/s/r inner wheel rim damaged.

Rust starting around fuel filler

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning switch faulty (1.4.B.1d)

Hazard warning switch insecure (1.4.B.1d)

Nearside Inner Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Inner Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Inner Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear wheel bearing has excessive play (2.6.2)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rust starting around fuel filler

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Hazard warning switch missing (1.4.B.1d)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)