1998 Suzuki Vitara

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Wheel arch. (5.3.6 (a) (i))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner wheel arch. (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Fuel Pipe/s corroded ()

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security all (6.2.2 (d) (i))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

all suspension correded

Registration plate lamp not working (1.1.C.1d)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear brake hose secured with a cable tie

Battery insecure (1.9.1)

Front passenger door cannot be opened from outside the vehicle (6.2.B.1b)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Rear Brake hose excessively deteriorated (3.6.B.4d)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1)

rear fuel pipes corroding

slight corrosion on chassis

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

O/S/F tyre wearing on inside

both rear bumper brackets insecure and corroded

exhaust catching body

exhaust heat shield insecure

fanbelt noisy

front to rear brakepipe slightly corroded

slight oil leak

Brake pipe excessively corroded (3.6.B.2c)

Driver's door cannot be opened from outside the vehicle (6.2.B.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Headlamp aim too low (1.8)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Headlamp aim too low (1.8)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Registration plate lamp not working (1.1.C.1d)

O/S/F tyre wearing on inside

both rear bumper brackets insecure and corroded

exhaust catching body

exhaust heat shield insecure

fanbelt noisy

front to rear brakepipe slightly corroded

slight oil leak

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

front discs pitted

front discs pitted

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front brake pads look low

Exhaust has a major leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front brake pads look low